At this point, most men and women throw out the battery. What many do not know, is it is actually possible to break down the direct sulfate to make the battery operational once again, and the fact that it is not required to throw the battery at this point.
But in a battery which has not been charged for some time, or that has been discharged completely and then left in that condition, the lead sulfate that’s shaped on the plates actually crystallizes. Since, when a charging current is applied to a battery within this state, the sulfate does not break down, this is devastating for the battery.
Drain the acid in the cells of the battery and pour in the Epsom salt mix.
Maintain the battery attached to the charger, and have a reading every hour or so (after detaching the battery) to monitor the charging process. The charging procedure could be done with rather quickly, or in some cases, could take up to fourteen hours. Once it is completed, and the battery is charged, you need to use a load to the battery to release it completely. Once it is discharged, you need to charge it , while employing a low stable current now around.
But is de-sulfating a battery an extremely intricate procedure, and hard to do?
Not whatsoever. You have to be careful, since the acid in the battery is really caustic. Before starting the process that is de-sulfation you want to use a pair of long rubber gloves and glasses to the eyes. You may stain and will need to do the de-sulfation on a concrete slab or rock flooring, as the acid is corrosive. As the acid should not be permitted to get into the soil, it must never be achieved on bare mud outdoors.
You need to take three or four gallons of distilled water, and heat it till it’s almost boiling.
The process is very elementary.
Now, the battery may be considered functional.
To understand precisely how reconditioning lead-acid batteries works, you have to completely comprehend just how the batteries themselves operate. The lead-acid battery is made up of plates of lead which are coated with lead oxide, and that can be bathed in sulfuric acid.
The Epsom salt mix will break down the lead sulfate, and return your battery to usable condition. Having replaced the knob attach the battery and place the charger. Chargers actually do the job at this process.
Once the battery sets out energy, direct sulfate forms on the plates of the battery, and also that which remains in the liquid isn’t sulfuric acid, but distilled water. When you charge the battery, then this process is reversed, while the liquid turns into acid, and the sulfate breaks down, leaving just the lead plates along with the lead oxide.